A D V I C E

1、Transporting, Loading & Unloading, Storing
When ALUTILE panels leave the factory, the procedures they have to experience are the followings: Transporting, Loading & Unloading, Storing, Unwrapping, Dead Lifting and Processing.
1) Try the best to prevent containers from being crashed because there are decorative panels insides. Maybe the crash will not affect panel's strength, but it will make a difference to the panel's appearance.
2) Pay attention to the position of loading & unloading, and the gravity center of containers. The main operation equipments are forklifts and hoists.
3) The surroundings around stocks should be dry, and keep away from some corrosive chemicals such as acid, alkali and salt etc. Lying on the floor horizontally with no higher than two layers, between which one backup plate (2cm thickness board) should be placed, as shown by the following drawings.
4) While unwrapping, snipping the steel belt firstly, then taking apart the steel stripe for angle connecting, thirdly taking apart the board of flank side and lifting the cover board, finally, opening the inner package.
5) When dead lifting, panels should be in the position of 10° angle with horizon and handled up and down by two persons. Please note that never do it in the horizontal direction and put something heavy on the panel to avoid panel deformation.
6) During processing, panels should lie horizontally on the plywood, and be put in pairs with face-to-face and base-to-base.